Princo's coatings are only a few thousandth of a millimetre thick, but harder than steel and chemically inert. That's why they sustainably reduce tool wear, cold welding and friction. Tools with Princo's coatings significantly boost productivity and quality in punching and forming operations.



Princo's coatings can :

Lower costs

Due to less tool wear, reduced lubricant consumption, fewer tool failures and calculable tool changes. You can cut manufacturing costs across the board.

Boost productivity

Due to substantially longer lives, higher cycle frequencies, reduced machine idle time and less workpiece finishing effort. You can punch, form and fine-blank with greater cost-effectiveness.

Enhance quality

Due to smoother surfaces, better dimensional stability, higher degrees of metal deformation and fewer manufacturing steps. You can establish higher standards in manufacturing.

Reduce environmental impact

Due to the use of environmentally friendlier lubricants, reduced lubricant consumption or even dry machining. You conserve resources and spend less on consumables.

Optimise tool production

Due to Princo's cutting tools. You can manufacture your punching and forming tools faster and at lower cost.

Dies and punches uncoated TiCN coated Rework 100'000 parts 250'000 parts Total tool life 100 % 500 % Savings for  1 million parts 0 USD 9'000 Clamps  steel strip 2.5 mm, 500 N/mm  Source  Balzers

Tool  Forming punch  Workpiece  steel sleeve  uncoated  no production possible  TiCN - coated  tool life 90'000 parts  tool cost USD 1'382  tool cost per part USD 0.014  Source  Balzers

　Contact Supplier

Add to Favorites