EARTH-CHAIN ENTERPRISE CO., LTD.
886-4-26303737
886-4-26303636
No. 551, Sec. 1, Gangbu Rd., Wu-Chi Dist., Taichung City 435, Taiwan
www.earth-chain.com

Products

Drill and end mill grinding machine series
SG HIGH SPEED DRILL GRINDER-X TYPE
ESG

SG HIGH SPEED DRILL GRINDER-X TYPE

1. Set up the drill to the collet holder

Follow up the steps 1,2,3,4 for set up the drill to the collet holder.(Without tightening)***as shown on diagram #1

2. Set up the diameter of drill

1. Turn right the scale annulus to be "0" position
2. Adjust the scale to meet the diameter of the drill.
***as shown on diagram #2

3. Set up the drill to the grinding position

Insert the collet holder with drill and turn right, then tighten the drill by collet holder for set up the grinding position.
***as shown on diagram #3
Attn: The scale annulus maybe not exact for the drill diameter, because of used drill or different model of drill. Any how, please always make sure the center edge of drill must be parallel with the gap of "Collet Holder". ***as shown on the right diagram

4. Grind the end gash of drill

Insert the collet holder with drill to the end gash grinding port and push to the grinding wheel slowly, then move left and right for de-burring to grind the end gash until the grinding sound disappeared. Take out the collet holder with drill and change to the other side (turn 180 degree) to grind again in same way as above mentioned.***as shown on diagram #4

5. Grind the center point of drill

Insert the collet holder with drill and push to the grinding wheel slightly, then move left and right for de-burring t to grind the center point of drill until the grinding sound disappeared. Take out the collet holder with drill and chang to the other side (turn 180 degree) to grind again in same way as above mentioned.
***as shown on diagram #5
Adjust the center point : Adjust "+" for bigger
Adjust "-" for smaller

6. Grind the secondary clearance angle of drill

Insert the collet holder with drill to the secondary clearance angle grinding port and push to the grinding wheel slowly to grind the secondary clearance angle of drill until the grinding. Take out the collet holder with drill and change to the other side (turn 180 degree) to grind again in same way as above mentioned.***as shown on diagram #6
Adjust the eng gash : Adjust "+" for bigger
Adjust "-" for smaller

Specification

Model NO. ESG-213X Motor 150W
Capacity Ø2mm ~ Ø13mm R.P.M. 5500 R.P.M.
Drill Angle 135° Weight 11.25 kg
Power Supply AC110V - AC220V Single Phase 50Hz/60Hz Grinding Wheel  
Standard Accessories
  ER collets Ø 2.5mm ~ Ø 13mm (12pcs)
  CBN Wheel #200x1pc and #400x1pc
Option Accessories
Order No. Description
ESG-213X-2D SDC Wheel #400 (For Carbide drill)
This machine is guaranteed for one year under normal operating 
(expendable parts and wheels are exceptions)

Mold
Machine
Vehicle
Contact Supplier
Browsing History
Scroll Up
EZB2B.TW uses cookies,IP to collect data and continually improve the website. By continuing to use this website, you must agree to the use of cookies and IP.